| RML 7-inch gun | |
| Origin: | United Kingdom |
| Type: | Naval gun Coast defence gun |
| Is Ranged: | YES |
| Is Artillery: | YES |
| Is Uk: | YES |
| Used By: | Royal Navy |
| Designer: | Royal Gun Factory |
| Design Date: | 1865 (7 & 6½ ton) 1874 (90 cwt) |
| Manufacturer: | Royal Arsenal |
| Unit Cost: | £425[1] |
| Variants: | 7 ton Mks I – IV 6½ ton Mks I – III 90 cwt |
| Part Length: | 7 ton : 126inches 6½ ton & 90 cwt : 111inches[2] |
| Cartridge: | 112lb115lb Palliser, Common, Shrapnel[3] 160lb double common shell |
| Caliber: | 7sing=onNaNsing=on |
| Velocity: | 7 ton : 1561ft/s 6½ ton : 1525ft/s 90 cwt : 1325ft/s |
| Max Range: | 5500yd |
The RML 7-inch guns were various designs of medium-sized rifled muzzle-loading guns used to arm small to medium-sized British warships in the late 19th century, and some were used ashore for coast defence.
These guns were the first to incorporate the new "Woolwich" rifling system, a modification of the French system, of from 3 – 9 broad shallow grooves after Britain abandoned the Armstrong "shunt" rifling system in May 1865 : "...M.L. 7inches guns in course of manufacture were rifled on this principle, upon which all of our heavy pieces since have been rifled. The 7inches referred to, and introduced into the service in 1865, were the first of the so-called Woolwich guns, which then meant "wrought iron M.L. guns built up on Sir W. Armstrong's principle, improved upon by hooking the coils over one another, and having solid ended steel barrels, rifled on the system shown above, for studded projectiles".[4]
All versions were constructed of a steel A tube surrounded by various numbers and thicknesses of wrought-iron coils. Rifling was 3 grooves with a uniform 1 turn in 35 calibres i.e. in 245inches.
The diagrams below show the progression from the original expensive Armstrong construction in Mk I of multiple relatively thin coils, through to the simplified and cheaper Woolwich design of Mk III.
This was a coast defence gun introduced in 1865 to replace the failed RBL 7-inch Armstrong gun.Three marks were produced.
This was a naval gun introduced in 1865 "...as a broadside or pivot gun for frigates, to replace the 7-inch B.L. and 68-pr S.B. guns, and is now very extensively used, 331 having been made... These guns are in total length 18inches shorter than the land service [i.e. 7-ton] 7inches gun, being a length more suited to the requirements of the Navy".[5] Some sources credit these weapons with the ability to pierce up to 7.7inches of armour.[6]
The following warships were armed with the gun :
This was a lighter (90 cwt = 4½ tons) low-powered naval gun introduced in 1874 as a broadside gun on unarmoured vessels, and not intended for attacking armour plate. Early models were made by simply turning off some of the jacket around 7inches 6½ ton guns, as firing with reduced charges placed less strain on the coils. Some new guns were made to similar design.
The following warships were armed with the gun :
The primary projectile for 7 ton and 6½ ton guns was Palliser shot or shell for attacking armoured warships, fired with a large "battering" charge for maximum velocity. All guns were also equipped with shrapnel shells for anti-personnel use and explosive common shells for attacking unarmoured targets. The "double" common shell was much longer than the standard common shell, and hence contained approximately twice as much gunpowder. It was unstable in flight and hence inaccurate beyond 2000yd but was considered useful for attacking wooden warships at ranges below 2000yd.[7]
This was the only RML heavy gun not to be issued with gas-checks.
